Fully digital circuit design with light-frequency-conversion sensor makes the oximetry modules more sensitive and accurate at low perfusion, more reliable and smaller in size.
Because of the digital signal transmission from the probe to the circuit, the special reinforced shielded cable is not required to connect to the probe, and the length of cable can be longer.
Detailed features are described in the following table:
Module 1
( LFC-5 )
|
> SpO2, Pulse Rate, Perfusion Index and Plethysmograph output
> Applicable to adult, pediatric, and neonate
> Better performance at low perfusion
> Artifact and noise suppression
> UART interface with BCI compatible communication protocol
> Wide range of working voltage from 4.2V to 6V
> Appropriate for use in multi-parameter patient monitors |
Module 2
(LFC-3)
|
> SpO2, Pulse Rate, Perfusion Index and Plethysmograph output
> Applicable to adult, pediatric, and neonate
> Artifact and noise suppression
> UART interface with BCI compatible communication protocol
> Low working voltage as 3V and low power consumption
> Applicable for use in battery powered oximeter, such as fingertip, wrist, or handheld oximeters. |
Custom-built
Module
|
> Customer selected output parameters with SpO2, Pulse Rate, Perfusion Index and Plethysmograph
> Applicable to adult, pediatric, and neonate
> Artifact and noise suppression
> Customer selected low perfusion performance level
> UART interface with BCI compatible communication protocol
> Customer selected working voltage (3V or 5V)
> PCB layout by customer requirement
> Applicable for use in special products |
|
